How do I set up custom DNS settings (M6)?

FibreStream Updated by FibreStream

For:

Mercku M6.

This article is a walkthrough for the Mercku M6 router. If you are using a TP-Link router, see this guide instead.
  1. Open your Internet browser. Enter 192.168.1.1 or setup.fibrestream.ca.
  2. Enter your password. Note: The password is typically the same password for your wireless network. There is no default password.
  3. Once logged in, select "Settings" from the top navigation bar.
  4. Select "Internet Settings" from the sub-menu.
  5. Change the DNS setting from "Automatic DNS" to "Manual DNS". Enter your custom DNS IP addresses.
  6. Select "Save".

Was this article helpful?

How do I change my wireless channel (M6)?

How do I enable Wi-Fi 5 compatibility (M6)?

Contact